Document Revision 4C Electra Elite IPK II
2 - 2 Features
SECTION 2 IMPORTANT NOTES
Simplifying Multiline Terminal Operation with One-Touch Keys
A multiline terminal user can access many features Service Codes (e.g., Service
Code 629 leaves a Message Waiting for a co-worker). To streamline the operation of
their telephone, a multiline terminal user can store these codes under One-Touch
Keys. This provides one-button operation for almost any feature. To find out more,
turn to the One-Touch Calling and One-Touch Serial Operation features.
Programmable Keys
When reading an instruction using programmable keys, you will see a notation similar
to (PRG 15-07 or SC nnn). This means that the key requires function code nnn, and
you can program this code Program 15-07 or by dialing Service Code 751 or 752.
Refer to the Programmable Function Keys feature for more information.
Using Handsfree
The manual assumes each extension has Automatic Handsfree. This lets a user just
press a line key or Speaker key to answer or place a call. For extensions without
Automatic Handsfree, the user must:
Lift the handset or press Speaker for Intercom dial tone.
Lift the handset or press Speaker, then press a line key for trunk dial tone.
Port Assignments
Port Calculation for Trunks:
The system detects the type of ETU (trunk or extension) and assigns the required
extension or trunk port to the slot. The system uses the next available port number – it
does not reserve any port.
To Next Page
Loading...
Need help?
General
