EasyManua.ls Logo

NEC Electra Elite IPK II System - Page 1035

NEC Electra Elite IPK II System
1190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Electra Elite IPK II Document Revision 4C
Unified Messaging 2 - 1011
Programming
10-09-01 DTMF and Dial Tone Circuit Setup
Assign at least one circuit for DTMF reception (type 0 or 1). Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
(default: 01~08 = 1, 9~32 = 2, 33~64 = 0)
11-07-01 Department Group Pilot Numbers – Dial
Assign a Department Group pilot number for the Voice Mail (eight digits maximum). The
extensions are assigned to the group in Program 16-02-01.
15-02-26 Multiline Telephone Basic Data Setup – MSG Key Operation Mode
Determine whether an extension MSG key should function as a Message key (0) or Voice Mail
key (1). If set as a Message key, the user can press the key to call the voice mail only when they
have new messages. If set as a Voice Mail key, it functions as a normal Voice Mail key (it is not
active if Centralized Voice Mail is used).
(default: 0)
15-02-28 Multiline Telephone Basic Data Setup – Message Waiting Lamp Color
Select whether the Message Wait LED located at the top of the multiline terminal flashes green
(0) or red (1) when a Message Wait indication is flashing.
(default: 1)
15-03-01 Single Line Telephone Basic Data Setup – SLT Signaling Type
For each Electra Elite IPK II voice mail extension, this option must be set to 0.
(default: 0)
15-03-03 Single Line Telephone Basic Data Setup – Terminal Type
Set all SLIU ports used for Voice Mail as type 1.
(default: 0)
15-03-09 Single Line Telephone Basic Data Setup – Caller ID Function - For External Module
This option must be set to 0 when voice mail is used or the integration code for the disconnect
function is incorrect.
(default: 0)
15-07-01 Programmable Function Keys
Assign a Voice Mail key to an extension. You must enter the Voice Mail key code (code 77)
followed by:
Your own extension number if you are setting up your own Voice Mail key.
A virtual extension number if you are setting up a Message Center key for a virtual extension.
A co-worker’s extension number if you are setting up a Message Center key for an installed
extension.
An uninstalled extension number if you are setting up a Message Center key for an uninstalled

Table of Contents

Related product manuals