Document Revision 4C Electra Elite IPK II
2 - 1028 Uniform Numbering Network
44-05-02 ARS/F-Route Table – Delete Digits
Enter the number of digits to be deleted from the dialed number [0~255 (255 = Delete all)].
(default: 0)
44-05-03 ARS/F-Route Table – Additional Dial Number Table
Enter the table number (defined in Program 44-06) for additional digits to be dialed (0~1000).
(default: 0)
44-05-04 ARS/F-Route Table – Beep Tone
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select whether or not a
beep is heard if a lower priority trunk group is used (0 = No Beep, 1 = Beep).
(default: 0)
44-05-05 ARS/F-Route Table – Gain Table Number for Internal Calls
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the gain table
number to be used for internal calls (0~500).
(default: 0)
44-05-06 ARS/F-Route Table – Gain Table Number for Tandem Connections
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the gain table
number to be used for tandem connection (0~500).
(default: 0)
44-05-07 ARS/F-Route Table – ARS Class of Service
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the Class of Service
to be used for ARS (0~16). An extensions ARS COS is determined in Program 26-04-01.
(default: 0)
44-05-08 ARS/F-Route Table – Dial Treatment
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the Dial Treatment
to be used (0~15). The Dial Treatments are determined in Program 26-03-01.
(default: 0)
44-05-09 ARS/F-Route – Maximum Digit
Assign Maximum Digit (0~24).
(default: 0)
44-05-10 ARS/F-Route Table – CCIS over IP Destination Point Code
Assign the Point Code (0~16367.
(default: 0)
44-05-11 ARS/F-Route Table – Network Specified Parameter Table
Assign Parameter Table (0~16).
(default: 0)
14-02-09 Analog Trunk Data Setup – Busy Tone Detection
0 = Disable (default)
1 = Enable
14-02-14 Analog Trunk Data Setup – Loop Start/Ground Start
0 = Loop Start (default)
1 = Ground Start
To Next Page
Loading...
