Document Revision 4C Electra Elite IPK II
2 - 1060 Voice Mail Integration (Analog)
=If leading digits are blanks, nothing will be sent to the Analog VM as integration.
Conditions
When an analog device is a member of a Department Group assigned as the VM
Department Group in PRG 45-01-01, it cannot perform an unsupervised transfer. When
the party where the call is being transferred answers, the transferred party is connected to
that party, and the analog device is released.
The periodic reminder message requires a DSP daughter board for Voice Response
System (VRS).
Ring Group calls do not follow extension call forwarding to voice mail.
Only one Voice Mail system can be installed in an IPK II system (Analog or Digital, but not
both in same system). This restriction is because only one Department Group can be
assigned for Voice Mail.
If installing an Analog Voice Mail System, any Analog station port (SLT port) can be
assigned to support the Analog Voice Mail system. With an Expanded Port Package, the
IPK II supports up to 176 Analog station ports (22 x 8 ports = 176).
If installing a Digital Voice Mail system (In-Skin product), an Analog station port (SLT port)
can be assigned to support the sending of DTMF tones and Disconnect Signal to support a
Fax server or other like products.
When using Programmed (45-01-15 = 1) integration and 45-04-XX is blank, no trailing
digits are sent. You can only allow the trailing digits to be sent by setting 45-05-XX to 1
(Version 1600 and Version 2100 or higher is required).
Stutter Dial Tone is supported to Single Line Telephones for Voice Mail Message Waiting.
Default Setting
Disabled
45-04-09 - Clear Down
String
Up to 4 digits
Default not assigned
9999 Up to 4 digits Up to 4 digits Clear down string.
Terminate
Program
Program 45-01-15
(0 = Fixed)
Program 45-01-17
(1=Yes or 0=No)
Program 45-01-15
(1 = Program)
Program 45-01-17
(1=Yes)
Program 45-01-15
(1=Program)
Program 45-01-17
(0=No)
Description
To Next Page
Loading...
