EasyManua.ls Logo

NEC Electra Elite IPK II System - Page 1102

NEC Electra Elite IPK II System
1190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Document Revision 4C Electra Elite IPK II
2 - 1078 Voice Over Internet Protocol (VoIP)
To connect a telephone to a LAN connection, the system allows using an Electra Elite IPK II digital IP
16-button multiline terminal (called an Electra Elite IPK II IP Phone), an Electra Elite IPK II digital
multiline terminal with an IP Adapter installed.
If connecting a LAN to a WAN (wide area network), follow the instructions included with the ADSL
modem or gateway device.
IP Address
Equipment/devices used in the Electra Elite IPK II LAN setup must have an IP address assignment. An
IP address assigns a unique address for each device. There are two types of IP addresses: Private and
Global. A Private IP address is not accessible through the internet – a Global IP address can be
accessed through the internet.
With a Private IP address, with equipment that does not access the internet directly, addresses can be
assigned to the equipment in Class A, B or C by assigning a number in the class range of numbers.
Class Allowed IP Address
Recommended
Environment
A 10.0.0.0 --- 10.22.255.255 Large Scale Network
B 172.16.0.0 --- 172.31.255.255 Mid Scale Network
C 192.168.0.0 --- 192.168.255.255 Small Scale Network
IPK II CPU
Switch
10Base - T/100 Base-T
(100Base-TX is
recommended)
PVA or IAD
HUB Card
(Switching Hub)
IPK II CPU
IPK II CPU

Table of Contents

Related product manuals