NEC Electra Elite IPK II System - Page 1124

Document Revision 4C Electra Elite IPK II
2 - 1100 Voice Response System (VRS)
 22-14-02 VRS Delayed Message for IRG – 1st Waiting Message Number
For each Ring Group, select the message number to be played as the first message (0~48).
This program is also used for VRS Waiting Message.
[default: 0 (No Message)]
 22-14-03 VRS Delayed Message for IRG – 1st Waiting Message Sending Count
For each Ring Group, set the number of times the first message is played (0~255). This program
is also used for VRS Waiting Message.
(default: 0)
 22-14-04 VRS Delayed Message for IRG – 2nd Waiting Message Number
For each Ring Group, select the message number to be played as the second message (0~48).
This program is also used for VRS Waiting Message.
[default: 0 (No Message)]
 22-14-05 VRS Delayed Message for IRG – 2nd Waiting Message Sending Count
For each Ring Group, set the number of times the first message is played (0~255). This program
is also used for VRS Waiting Message.
(default: 0)
 22-14-06 VRS Delayed Message for IRG – Tone Kind at Message Interval
For each Ring Group, determine what the caller hears between messages (0 = Ringback Tone,
1 = MOH, 2 = BGM). This program is also used for VRS Waiting Message.
(default: 0)
 22-14-07 VRS Delayed Message for IRG – Disconnect Time After the end of VRS Waiting Message
For each Ring Group, set the time (0~64800 seconds) the system waits after playing the VRS
message before disconnecting the call. To prevent the call from disconnecting, set this option to
0. This program is also used for VRS Waiting Message.
(default: 60)
 22-15-01 VRS Waiting Message for Department Group – 1st Waiting Message Start Time
For each Department Group, set the time (0~64800 seconds) the system waits before playing
the first message . This program is also used for VRS Waiting Message.
(default: 0)
 22-15-02 VRS Waiting Message for Department Group – 1st Waiting Message Number
For each Department Group, select the message number to be played as the first message
(0~48). This program is also used for VRS Waiting Message.
[default: 0 (No Message)]
 22-15-03 VRS Waiting Message for Department Group – 1st Waiting Message Sending Count
For each Department Group, set the number of times the first message is played (0~255). This
program is also used for VRS Waiting Message.
(default: 0)
 22-15-04 VRS Waiting Message for Department Group – 2nd Waiting Message Number
For each Department Group, select the message number to be played as the second message
(0~48). This program is also used for VRS Waiting Message.
[default: 0 (No Message)]