NEC Electra Elite IPK II System User Manual

Document Revision 4C Electra Elite IPK II
2 - 1102 Voice Response System (VRS)
 25-06-01 VRS/DISA One-Digit Code Attendant Setup – Next Attendant Message Number
Set up single digit dialing for Automated Attendant callers. For each VRS Message programmed
to answer outside calls (see Program 25-02-01), specify the digit the Automated Attendant caller
dials (1~9, 0,
, #). (Keep in mind that if you assign destinations to digits 3 and 4, outside callers
cannot dial system extensions.)
[default: 0 (No Setting)]
 25-06-02 VRS/DISA One-Digit Code Attendant Setup – Destination Number
Set up single digit dialing for Automated Attendant callers. For each VRS Message programmed
to answer outside calls (see Program 25-02-01), specify the destination reached (four digits
maximum) when the caller dials the single digit code.
 25-07-02 System Timers for VRS/DISA – VRS/DISA No Answer Time
If an Automated Attendant caller dials an extension that does not answer, the call waits this time
(0~64800 seconds) before rerouting to the Ring Group specified in PRG 25-03 and PRG 25-04.
This setting also affects unanswered DISA calls.
(default: 0)
 25-07-03 System Timers for VRS/DISA – Disconnect after VRS/DISA retransfer to IRG
Set the time (0~64800 seconds) for disconnecting a call after it is re-transferred to a ring group
by VRS/DISA.
(default: 60)
 25-08-01 DISA User ID Setup – Password
Set up password (six digits).
(default: No Setting)
 25-13-01 System Option for DISA – VRS Message Access Password
Enter the password DISA callers must dial before the system allows them to record, listen to or
erase VRS messages.
(default: No Setting)
 31-02-01 Internal Paging Group Assignment – Internal Paging Group Number
Assign extensions to Internal Paging Groups (0~64).
[default: 0 (No Setting) for IP Station, 1 for TDM Station]
 31-02-02 Internal Paging Group Assignment – Internal All Call Paging Receiving
Allow (1)/Prevent (0) All Call Internal Paging for each extension.
(default: 0)
 31-04-01 External Paging Zone Group – Paging Group Number
(default: Speakers 1~8 = Groups 1~8, 9 (CPUII) = Group 1)
 31-07-01 Combined Paging Assignments
Assign an external paging Group (0~8) to an Internal Paging Zone (0~64) for combined paging.
A combined Page simultaneously broadcasts to both the Internal and External Zones.
(default: 1)

NEC Electra Elite IPK II System Specifications

General

Brand	NEC
Model	Electra Elite IPK II System
Category	Telephone System
Language	English