NEC Electra Elite IPK II System - Page 116

Document Revision 4C Electra Elite IPK II
2 - 92 Automatic Route Selection
 44-05-04 ARS/F-Route Table – Beep Tone
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select whether or not a
beep is heard if a lower priority trunk group is used.
0 = No Beep
1 = Beep
 44-05-05 ARS/F-Route Table – Gain Table Number for Internal Call
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the gain table
number used for internal calls (0~500).
 44-05-06 ARS/F-Route Table – Gain Table Number for Tandem Connections
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the gain table
number used for tandem connection (0~500).
 44-05-07 ARS/F-Route Table – ARS Class of Service
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the Class of Service
used for ARS (0~16). An extension ARS COS is determined in Program 26-04-01.
 44-05-08 ARS/F-Route Table – Dial Treatment
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the Dial Treatment
used (0~15). Dial Treatments are defined in Program 26-03-01.
 44-05-09 ARS/F-Route – Maximum Digit
For each ARS/F-Route table (1~500) assign the priority (1~4). Set the maximum digits to be
dialed (1~99) for each ARS/F-Route table.
 44-06-01 Additional Dial Table
If an Additional Dial Number Table is entered in Program 44-05-03, define the additional dial
table (1~1000) to add digits in front of the dialed ARS/F-Route number (24 digits max: 1-9, 0
 #,
Pause). To enter a wild card/don’t care digit, press Line Key 1 to enter P (pause).
 44-07-01 Gain Table for ARS/F-Route Access – Incoming Transmit
44-07-02 Gain Table for ARS/F-Route Access – Incoming Receive
44-07-03 Gain Table for ARS/F-Route Access – Outgoing Transmit
44-07-04 Gain Table for ARS/F-Route Access – Outgoing Receive
Set the gain table to be used (1~500). If an extension dials ARS/F-Route number;
 The Extension Dial Gain Table is activated, which is assigned in Program 44-05.
 The Extension Dial Gain Table follows Outgoing transmit and Outgoing receive settings.
If the incoming call is transferred to another line using ARS/F-Route;
 The Tandem Gain Table is activated, which is assigned in Program 44-05.
 The Tandem Gain Table follows the Incoming transmit and Incoming receive settings for
incoming line, and Outgoing transmit and Outgoing receive settings for the outgoing line.
For ARS/F-Route calls, the CODEC gains defined in PRG 14-01-02 and PRG 14-01-03 are not
activated.
 44-08-01 Time Schedule for ARS/F-Route
Define the daily pattern of the ARS/F-Route feature. ARS/F-Route has 10 time patterns. These
patterns are used in PRG 44-09 and PRG 44-10. The daily pattern consists of 20 time settings.