Electra Elite IPK II Document Revision 4C
Call Waiting/Camp-On 2 - 163
15-02-12 Multiline Telephone Basic Data Setup – Off-Hook Ringing
For each extension, set the Off-Hook Ringing type.
0 = Muted (default)
1 = None
3 = Beep in Speaker
4 = Beep in Handset
5 = Speaker & Handset Beep
15-07-01 Programmable Function Keys
Assign a function key for Camp-On (code 35). This key is also the Callback key.
20-01-08 System Options – Trunk Queuing Callback Time
Set the Trunk Queuing callback time (default: 15). A Trunk Queuing Callback rings an extension
for this time.
20-01-09 System Options – Callback/Trunk Queuing Cancel Time
The system cancels an extension Callback or Trunk Queueing request after this time (default:
64800 seconds).
20-03-01 System Options for Single Line Telephones
The system cancels an extension Callback or Trunk Queueing request after this time (default:
64800 seconds).
20-06-01 Class of Service for Extensions
Assign a Class of Service to an extension (1~15).
20-09-01 Class of Service Options (Incoming Call Service) – Second Call for DID/DISA/DDI/DIL/
E&M
Enable (1)/Disable (0)) an extension ability to receive a second call from a DID, DISA, DIL, or
Tie line caller.
20-09-07 Class of Service Options (Incoming Call Service) – Call Queuing
Enable (1)/Disable (0).
20-13-05 Class of Service Options (Supplementary Service) – Intercom Off-Hook signaling
Enable (1)/Disable (0) the extension ability to receive Off-Hook Signaling.
20-13-06 Class of Service Options (Supplementary Service) – Automatic Off-Hook Signaling
(Automatic Override)
Allow a busy extension user to manually (0) or automatically (1) receive off-hook signals.
20-13-35 Class of Service Options (Supplementary Service) – Block Camp-On
Enable (1)/Disable (0)) an extension user ability to block callers from dialing 2 to camp-on.
20-18-06 Service Tone Timers – Interval of Call Waiting Tone
Set the time between call waiting tones. This also sets the time between Off-Hook signaling
alerts.
To Next Page
Loading...
