NEC Electra Elite IPK II System - Page 204

Document Revision 4C Electra Elite IPK II
2 - 180 Caller ID
6. Press the One-Touch key in which the number is to be stored or dial 1~9, 0. If you press Hold, the
next available One-Touch key is used. The display shows:
 If all One-Touch keys are used, the display shows TABLE IS FULL.
7. Press Hold. The display shows:
8. Enter the name to be associated with the stored number. Refer to Table 2-5 Keys for Entering
Names on page 2-178.
9. Press Hold. The display shows:
10. Press Speaker.
 The telephone returns to idle.
Temporary Memory
An unanswered call causes the Call History key (PRG 15-07 or SC 751: 08) to flash, indicating a new
call has been placed in the temporary memory. If enabled in programming, the telephone display shows
CHECK LIST.
1. Press the Call History key (PRG 15-07 or SC 751: 08) or press the LIST Softkey and CID.
 The last addition to the list is displayed.
2. Press the ARROW DOWN Softkey to scroll through the list of numbers in memory.
3. Press the DEL Softkey to delete the entry and scroll to the next entry.
4. The Call History key remains on as long as entries remain in memory.
5. To place a call back to a number in the temporary memory list, with the number to be dialed
displayed, press a line key or Speaker. (Refer to Table 2-5 Keys for Entering Names on page
2-178.)
 The outgoing call is placed.
Key ##:
xxxxxxxxxxxxx
KEY ##
-
KEY PROG ONE TOUCH