Document Revision 4C Electra Elite IPK II
2 - 190 Central Office Calls, Answering
11-12-30 Service Code Setup (for Service Access) – Specified Trunk Answer
If required, redefine the service code used to answer a specific trunk which is either ringing or on
hold (default: 672).
14-01-02 Basic Trunk Data Setup – Transmit Level
14-01-03 Basic Trunk Data Setup – Receive Level
Customize the transmit and receive levels of the CODEC Gain Types for each trunk.
Trunks: 1~200
14-02-02 Analog Trunk Data Setup – Ring Detect Type
For each trunk, enable delayed ringing (0) or immediate ringing (1).
Trunks: 1~200
14-05-01 Trunk Group – Trunk Group Number
Assign trunks to trunk groups then go to Program 14-06-01 below to set up Trunk Group
Routing.
Trunk Groups: 1~100
14-06-01 Trunk Group Routing
Set up trunk routes, and then go to Program 23-03-01 below to assign the trunk routes to
extensions. An extension user can use Universal Answer to answer a call if the ringing trunk is in
its assigned route.
Trunk Group Routes: 1~100
14-07-01 Trunk Access Map Setup
Set up the Trunk Access Maps. This sets the access options for trunks. Ring Group
programming overrides Access Map programming.
Trunk Access Maps: 1~200
15-01-05 Basic Extension Data Setup – Restriction for Outgoing Disable on Incoming Line
Enable (1)/Disable (0) supervised dial detection for an extension.
15-02-01 Multiline Telephone Basic Data Setup – Display Language Selection
Select the language to use on a telephone display:
15-02-02 Multiline Telephone Basic Data Setup – Trunk Ring Tone
Trunks ring extensions according to the Ring Tone Range selected in Program 22-03-01 and the
settings made with either Service Code 720
or Program 15-02-02.
0 = Japanese 5 = Spanish 10 = Swedish
1 = English 6 = Dutch 11 = Turkish
2 = German 7 = Portuguese 12 = Latin American Spanish
3 = French 8 = Norwegian
4 = Italian 9 = Danish
To Next Page
Loading...
