NEC Electra Elite IPK II System - Page 216

Document Revision 4C Electra Elite IPK II
2 - 192 Central Office Calls, Answering
 21-01-17 System Options for Outgoing Calls – Restriction Digit in Outgoing Disable on Incoming
Line
With the Outgoing Disable on Incoming Line feature, determine the number of digits (0~9) to be
dialed before the call should be disconnected.
 22-01-01 System Options for Incoming Calls – Incoming Call Priority
Determine if intercom calls (0) or trunk calls (1) have answer priority when both are ringing
simultaneously. Refer to Program 15-02-22 for lighting conditions.
 22-01-02 System Options for Incoming Calls – Incoming Call Ring No Answer Alarm
Enable (1)/Disable (0) the Incoming Call RNA Alarm. If enabled, the ring cadence changes for a
call that rings longer than the time set in PRG 22-01-03.
 22-01-03 System Options for Incoming Calls – Ring No Answer Alarm Time
Set the Ring No Answer Alarm interval (0~64800 seconds). If a trunk rings a multiline terminal
longer than this time, the system changes the ring cadence.
 22-01-04 System Options for Incoming Calls – DIL No Answer Recall Time
If an incoming trunk call rings longer than this time, it reroutes to the Ring Group set in Program
22-08-01 (default = 0 seconds).
 22-02-01 Incoming Call Trunk Setup
Select the trunk type (0~7) for each trunk at each time mode (1~8): (default = Normal).
Trunks: 1~200
 22-03-01 Trunk Ring Tone Range – Ring Tone Pattern
Assign Ring Tone Ranges to trunks. Trunks ring extensions according to the Ring Tone Range
selected in PRG 22-03-0 and the settings made with either Service Code 720 or PRG 15-02-02.
 22-04-01 Incoming Extension Ring Group Assignment
Assign extensions to ring groups.
 22-05-01 Incoming Trunk Ring Group Assignment
To have trunks ring extensions, assign trunks to a Ring Group. The incoming ring group
assignment programmed in PRG 41-03-01 overrides the setting in this program.
 22-06-01 Normal Incoming Ring Mode
Indicate whether the trunks in the Ring Group assigned in PRG 22-04-01 should ring (1) or not
ring (0).
 22-07-01 DIL Assignment
Assign the destination extension for each DIL incoming trunk (001~200).
 For this selection to work, set Program 22-02-01 to 4 = DIL.
0 = Normal 4 = DIL
1 = VRS 5 = E&M Tie Line
2 = DISA 6 = Delayed DID
3 = DID 7 = ANI/DNIS