Electra Elite IPK II Document Revision 4C
Central Office Calls, Placing 2 - 197
Handsfree
Long Conversation Cutoff
Microphone Cutoff
Programmable Function Keys
Trunk Group Routing
Trunk Groups
Programming
10-03-03 ETU Setup (for SLI PKG Setup) – Transmit Gain Level (S-Level)
10-03-04 ETU Setup (for SLI PKG Setup) – Receive Gain Level (R-Level)
For for SLI package, Customize the transmit and receive level of the CODEC Gain Type for 500/
2500 type single line telephones.
11-01-01 System Numbering – Service Code
Setup number to use for Service codes to access trunks.
11-09-01 Trunk Access Code
If required, change the single-digit Trunk Access Code (normally 9). If you change this code, you
must also review the settings in PRG 11-01-01 for the new code selected.
11-09-02 Trunk Access Code – 2nd Trunk Route Access Code
Assign the Service Code set up in PRG 11-01-01 for Alternate Trunk Route Access.
11-10-27 Service Code Setup (for System Administrator) – Trunk Port Disable for Outgoing Calls
Define the service code which should be used by an extension user to block a trunk from being
used for outgoing calls (Default: 645).
11-11-13 Service Code Setup (for Setup/Entry Operation) – Display Language Selection for
Multiline Terminal
Select the service code used at an extension to change the displayed language on a multiline
terminal display (default: 678).
11-12-01 Service Code Setup (for Service Access) – Bypass Call
Define the service code used by an extension user to select outgoing Trunk Group (code 704).
14-01-01 Basic Trunk Data Setup – Trunk Name
To make identifying calls easier, assign a name to each trunk.
14-01-02 Basic Trunk Data Setup – Transmit Level
14-01-03 Basic Trunk Data Setup – Receive Level
Assign a CODEC Gain Type to each trunk. This sets the gain (amplification) for the selected
trunk.
To Next Page
Loading...
