NEC Electra Elite IPK II System - Page 225

Electra Elite IPK II Document Revision 4C
Central Office Calls, Placing 2 - 201
To place a call using Trunk Group Routing:
1. Go off-hook.
2. Dial 9.
 If your system has an Alternate Trunk Route Access code, you may dial that instead.
3. Dial the number.
- OR -
1. At the multiline terminal, press the Trunk Group Routing key (PRG 15-07-01 or SC 752: 05).
2. Dial the number.
To place a call over a specific trunk:
1. Dial
#9.
2. Dial the line number (e.g., 005 for line 5).
3. Dial the number.
- OR -
1. At the multiline terminal, press line key (PRG 15-07-01 or SC 752: 001 to 200).
2. Dial the number.
To busy out a trunk from outbound usage:
1. Press Speaker + 645 + Trunk Number (001~200) + 1.
 The user which busied out the trunk still has access to it. All other users are blocked from seizing it to place an
outgoing call. The trunk, however, can still be answered by any users programmed with the trunk access.
To Remove a Trunk from a Busied Out State:
1. Press Speaker + 645 + Trunk Number (001~200) + 0.