Electra Elite IPK II Document Revision 4C
Dial Tone Detection 2 - 295
21-01-05 System Options for Outgoing Calls – Dial Tone Detection Time
If dial tone detection is enabled, the system waits this time for the Telco to return dial tone. When
this time expires, the system assumes dial tone is not present. To disable this time (and have
the system wait continuously), enter 0.
21-01-06 System Options for Outgoing Calls – Dial Pause at First Digit
If Dial Tone Detection is disabled, the system waits this time before sending dialed digits. If
using Dial Tone Detection, this time should be set longer than the time set in PRG 21-01-05,
otherwise, if this time is set shorter than PRG 21-01-05, Dial Tone Detection is satisfied and
PRG 21-01-05 is disregarded (not used).
Operation
Dial Tone Detection is automatic if enabled in programming.
To Next Page
Loading...
