NEC Electra Elite IPK II System - Page 334

Document Revision 4C Electra Elite IPK II
2 - 310 Digital Voice Mail
Programming
 10-09-01 DTMF and Dial Tone Circuit Setup
Assign at least one circuit for DTMF reception (type 0 or 1).
Use the following as a guide when allocating DTMF receivers:
 In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
 In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
 11-07-01 Department Group Pilot Numbers – Dial
Assign a Department Group pilot number for the Voice Mail (eight digits maximum). The
extensions are assigned to the group in Program 16-02-01.
 15-02-26 Multiline Telephone Basic Data Setup – MSG Key Operation Mode
Determine whether an extension MSG key should function as a Message key (0: default) or
Voice Mail key (1). If set as a Message key, the user can press the key to call the voice mail only
when they have new messages. If set as a Voice Mail key, it functions as a normal Voice Mail
key (it is not active if Centralized Voice Mail is used).
 15-02-35 Multiline Telephone Basic Data Setup – Message Waiting Lamp Cycle for Calling
Extension (Version 1600 or higher required)
1 = Cycle 1
2 = Cycle 2
3 = Cycle 3 (default)
4 = Cycle 4
5 = Cycle 5
6 = Cycle 6
7 = Cycle 7
 15-02-36 Multiline Telephone Basic Data Setup – Message Waiting Lamp Cycle for Called
Extension (Version 1600 or higher required)
1 = Cycle 1
2 = Cycle 2 (default)
3 = Cycle 3
4 = Cycle 4
5 = Cycle 5
6 = Cycle 6
7 = Cycle 7
 15-02-37 Multiline Telephone Basic Data Setup – Voice Mail Message Wait Lamp Color (Version
1600 or higher required)
0 = Green
1 = Red (default)