NEC Electra Elite IPK II System - Page 354

Document Revision 4C Electra Elite IPK II
2 - 330 Direct Inward Dialing (DID)
 22-10-01 DID Translation Table Setup
Assign the start and end range of DID Translation Table entries (1~2000) to each DID
Translation Table (1~20).
 22-11-01 DID Translation Number Conversion – Received Number
For each DID Translation Table entry (1~2000), specify the digits received by the system (eight
maximum).
 22-11-02 DID Translation Number Conversion – Target Number
For each DID Translation Table entry (1~2000), specify the extension the system dials after
translation (24 digits maximum).
 22-11-03 DID Translation Number Conversion – DID Name
For each DID Translation Table entry (1~2000), specify the name that should show on the dialed
extension display when it rings (12 characters maximum).
 22-11-04 DID Translation Number Conversion – Transfer Operation Mode
For each DID Translation Table entry (1~2000), specify the condition required to transfer the call
to the destination defined in PRG 22-11-05 and PRG 22-11-06.
 22-11-05 DID Translation Number Conversion – Transfer Destination Number 1
 22-11-06 DID Translation Number Conversion – Transfer Destination Number 2
For each DID Translation Table entry (1~2000), specify the first and second Transfer
Destinations if the caller receives a busy or no answer (defined in PRG 22-11-04).
Destination Options:
0 = No Setting
1~100 = Incoming Group
102 = In-Skin/External Voice Mail
103 = Centralized Voice Mail
201~264 = Extension Group
400 = Valid Extension Number/DID termination to VRS
401 = DISA
501~548 = DISA/VRS Message
1000~1999 = Speed Dial Bin Number (000~999)
 If the Transfer Destinations are busy or receive no answer, those calls are transferred to the final transfer
destination (Program 22-10).
 22-11-07 DID Translation Number Conversion – Call Waiting
For each DID Translation Table entry (1~2000), specify whether or not Call Waiting should be
allowed (Enable (1)/Disable (0)).
 22-11-08 DID Translation Number Conversion – Maximum Number of DID Calls
For each DID Translation Table entry (1~2000), specify the maximum number of DID calls.
0 = Unlimited (default)
1~200