NEC Electra Elite IPK II System - Page 356

Document Revision 4C Electra Elite IPK II
2 - 332 Direct Inward Dialing (DID)
 25-02-01 VRS/DISA VRS Message
For each trunk port and each night mode, select the message source (0 = No Message,
1 = VRS, 2 = ACI, 3 = S LT), assign the VRS message number used as the Automated
Attendant Message for each trunk, which is assigned as VRS/DISA [with VRS = 01~48 (VRS
message number), with ACI = 1~4 or 01~16 (ACI group number), with SLT = 1~8 or 01~64
(Department Group number)].
Trunk Ports:
001~200
Night Time Service Modes:
1~8
 25-03-01 VRS/DISA Transfer Ring Group With Incorrect Dialing
For each trunk port, set what happens to a call when the DISA or Automated Attendant caller
dials incorrectly or waits too long to dial. The call can either disconnect (0) or Transfer (1) to an
alternate destination (a ring group, In-Skin/External, Centralized). When setting the DISA and
DID Operating Mode, make an entry for each Night Service mode.
Ring Groups:
1~100
102 = In-Skin/External Voice Mail
103 = Centralized Voice Mail
Trunk Ports:
001~200
Night Service Time Modes:
1~8
 25-04-01 VRS/DISA Transfer Ring Group With No Answer/Busy
For each trunk port (001~200), set the operating mode of each DISA trunk. This sets what
happens to the call when the DISA or Automated Attendant caller calls a busy or unanswered
extension. The call can either disconnect (0) or Transfer (1) to an alternate destination (a ring
group, In-Skin/External, Centralized). When setting the DISA and DID Operating Mode, you
make an entry for each Night Service mode.
Ring Groups:
1~100
102 = In-Skin/External Voice Mail
103 = Centralized Voice Mail
Trunk Ports:
001~200
Night Service Time Modes:
1~8
 25-05-01 VRS/DISA Error Message Assignment
For each trunk that is answered by the VRS, enter the VRS message (1~48) the outside caller
hears if they dial incorrectly after answer. If you enter 0, the call reroutes according to Program
25-03 and Program 25-04. Make one entry for each Night Service mode.