Document Revision 4C Electra Elite IPK II
2 - 334 Direct Inward Dialing (DID)
25-07-11 System Timers for VRS/DISA – VRS/DISA Answer Delay Time
Set the time the system waits after receiving an incoming VRS/DISA call before the system
automatically answers the call (0~64800 seconds).
25-07-13 System Timers for VRS/DISA – VRS/DISA Busy Tone Interval
If a DISA caller dials a busy extension (and Program 25-04-01 = 0), the system plays busy tone
for this time before disconnecting (0~64800 seconds).
25-07-14 System Timers for VRS/DISA – Delayed VRS Answer Time
Assign the delay time from switching from a normal incoming status to DID mode. If this time is
set to 0, the call switches to DID mode immediately (0~64800 seconds).
34-01-01 E&M Tie Line Basic Setup – DID/E&M Start Signaling
Set the start signaling mode for DID and tie trunks. DID and tie trunks can use either immediate
start or wink start signaling.
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
DID Call by Time Schedule (in addition to the above programming)
11-10-35 Service Code Setup (for Administrator) – Dial-In Mode Switching
Assign the service code Dial-In Mode Switching (Default: Not Set)
15-07-01 Programming Function Keys
Assign a function key for one-touch access to the Dial-In Mode Switching setup code (Code 88).
20-07-26 Class of Service Options (Administrator Level) – Dial-In Mode Switch
Enable (1)/Disable (0) an extension user ability to manually change Dial-In Modes.
22-02-01 Incoming Call Trunk Setup
For each Night Service Mode, enter service type 8 when the trunk should be a DID (DDI) Mode
Switching trunk.
22-11-02 DID Translation Table Number Conversion – Target Number
For each DID Translation Table entry (1~2000), specify the extension the system dials after
Translation in PRG 22-17 (24 digits maximum).
Do not assign Received Digits in PRG 22-11-01 when using DID Call by Time Schedule.
22-17-01
through
22-17-04 Dial-In Conversion Table Area Setup for Time Pattern
Define the Time Zone and Dial-In Conversion Table (PRG 22-11) for each Time Pattern.
30-03-01 DSS Console Key Assignment
Customize DSS Console keys to function as Dial-In Mode Switching keys. Use the key [when
defined as a Dial-In Mode Switching key (code 88)] to manually switch between Dial-In Modes.
To Next Page
Loading...
