Document Revision 4C Electra Elite IPK II
2 - 372 Distinctive Ringing, Tones and Flash Patterns
15-02-38 Multiline Telephone Basic Data Setup – Voice Mail Message Wait Lamp Cycle (Version
1600 or higher required)
1 = Cycle 1
2 = Cycle 2 (default)
3 = Cycle 3
4 = Cycle 4
5 = Cycle 5
6 = Cycle 6
7 = Cycle 7
20-13-49 Class of Service Options (Supplementary Service) – BLF Indication on CO Incoming State
(Version 1600 or higher required)
Turn Off (0) or On (1) the BLF Indication when a Ring Group call rings a station. This
assignment does not apply to single line telephones.
20-15-01
through
20-15-11 Ring Cycle Setup
Define the ringing cycles for each ring tone, when Synchronous Ringing is disabled.
22-03-01 Trunk Ring Tone Range
Set the ring tone range (1~9) for each trunk.
80-01-01 Service Tone Setup – Repeat Count
Customize the system basic tones and system service tones. You must reset the system for the
changes to take affect.
80-01-02 Service Tone Setup – Basic Tone Number
The following features require that the system tones listed below be changed to match the table.
After changing these settings the KSU must be reset for the changes to take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
Tone 06
Unit Basic Tone Duration Gain Level
1 11 ~ 480/620Hz -13/-13dB 300ms 32
2 0 - No Tone 300ms 32
30 - No Tone 0ms
40 - No Tone 0ms
50 - No Tone 0ms
60 - No Tone 0ms
70 - No Tone 0ms
To Next Page
Loading...
