Document Revision 4C Electra Elite IPK II
2 - 380 Door Box
Each channel in the PGD(2)-U10 ADP has a jumper which must be set for Door Box
operation. Refer to the Electra Elite IPK II System Hardware Manual for additional details.
The PGD(2)-U10 ADP can be connected only to an ESIB(8)-U20 ETU. if the PGD(2)-U10
ADP is connected to an ESIE(8)-U20 ETU, the PGD(2)-U10 ADP is not recognized.
When a ESIB(8)-U20 ETU has an ESIE(8)-U20 ETU installed [ESIB/E(16)], the
PGD(2)-U10 ADP has both channels available for Paging, MOH, External Ringers and
Door Box according to strapping on ports 1~8. The corresponding port on the ESIE(8)-U20
ETU does not support a station or other hardware (it is used by the PGD(2)-U10 ADP for
channel 2).
When a ESIB(8)-U20 ETU is installed without an ESIE(8)-U20 ETU installed, a
PGD(2)-U10 ADP installed on ports 1~8 is recognized, but only channel 1 on the
PGD(2)-U10 ADP is supported. Channel 2 is not available.
ESIB(8)-U10 ETUs and ESIE(8)-U10 ETUs do not support the PGD(2)-U10 ADP.
A Single Line Telephone (SLT), connected to an APR does not ring when the Door Phone
rings the multiline telephone.
D
term
cordless telephones are not supported with the Door Box feature.
Door Boxes do not ring Logged In ACD Agents.
Default Setting
Disabled
System Availability
Terminals
All Stations
Required Component(s)
PGD(2)-U10 ADP
Programming
10-03-01 ETU Setup (For ESI PKG) – Terminal Type (B1)
10-03-06 ETU Setup (For ESI PKG) – Terminal Type (B2)
For ESI package support, set the terminal type to 8 [PGD (for Door Box)]. First set 10-03-01 to
0 with no device plugged into that port, then plug the device in and the system should recognize
it as a door box, and set PRG 10-03-06.
To Next Page
Loading...
