NEC Electra Elite IPK II System - Page 415

Electra Elite IPK II Document Revision 4C
D
term
Cordless II Terminal 2 - 391
Operation
To program the D
term
Cordless II:
1. Press and hold down
 and #, then press TALK. The F1 LED flashes red.
2. Press R/VOL repeatedly to scroll through the line key (LK) and feature options for function key F1.
3. Press MUTE to select the displayed line key or feature.
4. When a Line Key is assigned, press MUTE once to enter the Off-Hook Ringing ON or OFF Mode.
Press R/VOL to toggle between /TALK for ON or /NO TALK for OFF.
5. Press MUTE to advance to the next function key (F2 ~ F4).
6. After programming F4, press MUTE to advance to Global Off-Hook Ringing Assignment.
7. Press R/VOL to turn Global Off-Hook Ringing ON/OFF (LCD indicates ON or OFF).
8. Press TALK to exit.
 Function keys F1 ~ F4 can be programmed as Line Keys 1~16, Redial (LNR/SPD), Answer (ANS), Feature
(FNC), or Recall. When assigned, these keys operate the same as on an NEC Multiline Terminal.
 When initially installed, function keys F1~F4 default to Line Keys 1~4 respectively and Off-Hook Ringing
defaults to ON.
 Global Off-Hook Ringing must be ON (default) for any Function key to work with Off-Hook Ringing.
To place an internal call:
1. Press TALK. icon is displayed.
2. Dial the Station Number.
- OR -
Press (F1~F4), programmed for Direct Station Selection (DSS).
3. Announce the call after tone burst or wait for call to be answered.
To place an outside call:
1. Press TALK. icon is displayed.
2. Dial the Station Number.
- OR -
Press (F1~F4) programmed for Direct Station Selection (DSS).
3. Announce the call after the tone burst or wait for call to be answered.