Document Revision 4C Electra Elite IPK II
2 - 394 D
term
Cordless II Terminal
3. Press Desk to select multiline terminal.
Switching must be accomplished while both terminals are idle.
A call in progress cannot be switched. When tried, it is dropped.
Switching held calls is not recommended because LED indications are not provided.
The Power LED and the applicable position LED are on to indicate selection.
To switch from Desk to Cordless using the Redial Key:
1. Verify that the Base Unit is in Desk mode.
2. Remove the battery.
3. Press and hold
and # on the handset.
4. Install the battery while holding these keys.
5. After the handset beeps one time, release the keys.
6. The handset is in Setup mode.
7. Press HOLD to display the current mode (Digital/Redial).
8. Press F2 and then HOLD.
9. The handset displays Digital (F8), and changes REDIAL program to Desk/Cordless Softkey
Switching mode.
10. Press TALK to restore standby mode.
11. Press REDIAL to test this feature.
12. The Base Unit automatically changes from Desk to Cordless.
This is a one time operation, but one of the F1~F4 keys can be programmed for the redial function.
Cordless II Base Unit Controls
To Next Page
Loading...
