Electra Elite IPK II Document Revision 4C
Electra Elite IPK Terminals 2 - 419
With non-IP Electra Elite IPK II Terminals, up to two adapters can be installed in a
telephone. For compatibility of multiple adapter units, refer to the following table:
An AC-2R Unit/AC-3R Unit (AC Adapter) is required when any of the following adapters is
installed in an IPK Terminal:
AP(R)-R Unit
CT(U)-R Unit
HF-R Unit
IPR-R Unit (When in-line power is used, power over Ethernet, is not provided.)
DCR-60-1 Console
An AC-2R Unit/AC-3R Unit (AC Adapter) is required for the ITH-16D-2 and ITH-8D-2
telephones when in-line power, power over Ethernet, is not provided or the ILPA-R is not
used.
The distance from the KSU for Electra Elite IPK II DTH Multiline Terminals can be extended
when local AC power is provided. When the Electra Elite IPK II terminal is powered by a
local AC-2R/AC-3R Unit (AC Adapter), a built in Long Line Adapter allows these
telephones to be connected up to 2,000 feet by Twisted 1-pair 24AWG Cable.
The WM-R Unit (Wall Mount Unit) is required when any adapter is installed in an Electra
Elite Terminal and the terminal is to be wall mounted.
Default Settings
None
AD(A)-R AP(A)-R AP(R)-R CT(A)-R CT(U)-R HF-R IP-R(IPK)
AD(A)-R
XXXXX–
AP(A)-R X
–XX X–
AP(R)-R X–
XX X–
CT(A)-R XXX
–X –
CT(U)-R XX
X - X–
HF-R XXXXX
–
IP-R(IPK) ––––––
X = Compatible
– = Not compatible
= The Voice Application of CT(U) cannot be used when installed with AP(A/R)-R Unit.
To Next Page
Loading...
