Document Revision 4C Electra Elite IPK II
2 - 446 Flash
Programming
 11-12-42 Service Code Setup (for Service Access) – Flash on Trunk Lines
Assign Service Code, default = #3.
 14-02-03 Analog Trunk Data Setup – Flash Type
Always set this to 0 for Open Loop Flash.
 14-02-04 Analog Trunk Data Setup – Hooking Type
Set to 0 for Timed Flash (hooking) or set to 1 for Disconnect (cut). Default is 0. The user can
press the Flash key while on a call to implements this.
 15-02-05 Multiline Telephone Basic Data Setup – Transfer Key Operation Mode
For the Cordless Lite/Cordless Lite II telephone user to use the flash function, this option must
be set to 2. This changes the Transfer key to a Flash key.
 15-03-04 Single Line Telephone Basic Data Setup – Flashing
Select Yes (1)/No (0) for the ability to hookflash for system feature access. Default is 1.
 81-10-07 COI Initial Data Setup – Hookflash Time Selection 1
Set the Flash duration to 0 (20 ms)~15(5 seconds) for analog trunk [COI( )-U( ) ETU] circuits in
PRG 81-10-07. Default is 9 (600ms)
 81-10-08 COI Initial Data Setup – Hookflash Time Selection 2
Set the open loop disconnect duration to 0 (20 ms)~15(5 seconds) for analog trunk [COI( )-U( )
ETU] circuits PRG 81-10-08. Default is 14 (3 seconds)
Operation
To flash the trunk you are on:
From a Multiline Terminal
1. Press Recall.
From a Single Line Telephone
1. Hookflash.
2. Dial
#3.
To Next Page
Loading...
Need help?
General
