NEC Electra Elite IPK II System - Page 52

Document Revision 4C Electra Elite IPK II
2 - 28 Alarm
Programming
 20-01-06 System Options – Alarm Duration
Set the duration of the Alarm signal (0~64800 seconds).
Operation
To set the alarm:
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 727.
3. Dial alarm type (1 or 2).
 Alarm 1 sounds only once. Alarm 2 sounds each day at the preset time.
4. Dial the alarm time (24-hour clock).
 For example, for 1:15 PM dial 1315.
A confirmation tone is heard if the alarm has been set. If the alarm was not set, an error tone is heard instead.
5. At the multiline terminal, press Speaker to hang up.
- OR -
At the single line telephone, hang up.
To silence an alarm:
1. At multiline terminal, press Exit.
- OR -
At the single line telephone, lift the handset.
 The single line set user hears Music on Hold when the handset is lifted.
To check the programmed alarm time at a multiline terminal:
1. Press Help.
2. Dial 727.
3. Dial alarm type (1 or 2).
 The programmed time displays.
4. Press Exit.