NEC Electra Elite IPK II System User Manual

Document Revision 4C Electra Elite IPK II
2 - 524 Internal Hub
 85-01-06 Hub(8) LAN Setup – Flow Control, Full-Duplex
Full-Duplex – 802-3x. When Enabled (1), a switch applies flow control to a full-duplex ingress
port while an output queue is congested. (Only applicable when PRG 85-01-01 is disabled and
PRG 85-01-03 is full-duplex.) Default is 0.
 85-02-01 Hub(8) VLAN Setup – VLAN Mode
Enable (1)/Disable (0) VLAN. Default is 0.
 85-02-02
through
85-02-09 Hub(8) VLAN Setup – Port VLAN ID
Define the VLAN ID for each port (1~4095). Default is 1 for all programs.
 85-03-01 Priority Setup – Default Priority
Disable (0) assigns untagged frames to either the Low (2) or High (3) queue and tags them with
a priority assigned in PRG 85-03-03 (high) or PRG 85-03-04 (Low). Default is 0.
 85-03-02 Priority Setup – RX High
Establish the minimum threshold (1~7) for frames designated for the high priority queues.
Default is 1.
 85-03-03 Priority Setup – TX High
When PRG 85-03-01 is set to High, untagged frames are marked with this priority setting (1~7).
Previously tagged frames are unchanged. Default is 7.
 85-03-04 Priority Setup – TX Low
When PRG 85-03-01 is set to Low, untagged frames are marked with this priority setting (1~7).
Previously tagged frames are unchanged. Default is 0.
 85-04-01 Port Mirroring Setup – Port Mirroring
Enable (1)/Disable (0) Port Mirroring. Default is 0.
 85-04-02 Port Mirroring Setup – Source Port
Define the port to be monitored (1~8). Default is 1.
 85-04-03 Port Mirroring Setup – Target Port
Define the port where the monitored ports data should be simultaneously transmitted (1~8).
Default is 1.
 85-05-01 Hub(8) VLAN Group Settings – VLAN ID
Define the 802.1q VLAN ID(0~4095) . Default is 0.
 85-05-02 Hub(8) VLAN Group Settings – Port
Input data represents the eight physical ports of the Hub(8), numbered from left to right as 8 to 1
(00000000~11111111). Setting a port to 1 enables the port to allow traffic from the VLAN ID
specified in PRG 85-05-01. Default is 00000000.
 85-05-03 Hub(8) VLAN Group Settings – Tag Egress Retention
Input data represents the eight physical ports of the Hub(8), numbered from left to right as 8 to 1
(00000000~11111111). At the point of egress, should VLAN tags be retained or removed?
(Many Ethernet device do not process VLAN tagged packets.) Setting a port to 1 permits VLAN
tags to be retained. Default is 00000000.

NEC Electra Elite IPK II System Specifications

General

Brand	NEC
Model	Electra Elite IPK II System
Category	Telephone System
Language	English