NEC Electra Elite IPK II System - Page 588

Document Revision 4C Electra Elite IPK II
2 - 564 IP Station (SIP) – MG16
System Availability
Terminals
SIP Terminals Compliant with RFC 3261, RFC 3262, RFC 3264 (Session Description Protocol),
RFC 1889 (Real Time Protocol).
PVA(X)-U20 ETU with MG16 Application Package 1.51 or higher.
IPK II CPU Release 1.50 or higher.
PVA(X)-U( ) ETU with PVA Combo Application Package 1.00 or higher and Elite IPK II CPUII
Version 2000 or higher.
Related Features
None
Programming
VoIP Settings:
When the PVA(X)-U( ) ETU is first purchased it has a factory default package installed. You must load
the MG16 Application for the Elite IPK II KSU to recognize the VoIP MG16 ETU. [Reference the
PVA(X)-U( ) ETUs Firmware upgrade installation procedure].
 10-19-01 VoIP DSP Resource Selection (Version 1600 or higher required)
Select type of VoIP ETU DSP Resource. This program setting has no affect on the terminal/
trunk port assignment or usage.
Entries: 0 = Common (Used for both IP Extensions and Trunks), 1 = Extension, 2 = Trunks, 3 =
Networking
(Default: 0)
 10-26-01 IP System Operation Setup – Peer to Per Mode (Version 1600 or higher required)
0 = Off
1 = On
(default: 1)
 10-26-03 IP System Operation Setup – SIP Peer to Per Mode (Version 1600 or higher required)
0 = Off
1 = On
(default: 1)