Electra Elite IPK II Document Revision 4C
Alarm Reports 2 - 35
Conditions
Alarm Reports and System Information Reports can be output to KSU COM Port 1 or a
CTU/ CTA adapter.
The IPK II supports the following Alarms to be output to the LCD of a multiline terminal:
SMDR Buffer Full
CPU-LAN link Error
The IPK II does not support printouts of the following Alarms:
Power Failure
RAM Backup Battery Error
Networking Keep Alive Error
Program 15-02-19 must be set to Non-Procedural Mode when using CTA/CTU adapters for
printouts.
Up to 12 System Alarm times can be scheduled to print on a Monthly, Daily, and Hourly
time frame. The report indicates both Major and Minor Alarms.
System Information Reports cannot be set to output at a scheduled time.
15 2-7 none Not Install
16 2-8 none Not Install
17 3-1 none Not Install
18 3-2 none Not Install
19 3-3 none Not Install
20 3-4 none Not Install
21 3-5 none Not Install
22 3-6 none Not Install
23 3-7 none Not Install
24 3-8 none Not Install
Table 2-4 Sample System Information Printout (Continued)
System Information 05/18/2006 11:02
slot location type assign port condition note
To Next Page
Loading...
