NEC Electra Elite IPK II System - Page 606

Document Revision 4C Electra Elite IPK II
2 - 582 IP Trunk (SIP) – MG16
 PVA(X)-U( ) ETU/Combo Card LED Indications:
 Non Peer-to-Peer MEGACO IP Station and SIP IP Station calls are indicated by a Flashing
RED LED.
 CCISoIP Trunk and SIP Trunk calls are indicated by a Solid RED LED.
Default Setting
None
System Availability
Terminals
SIP Trunks Compliant with RFC 3261
Required Component(s)
PVA(X)-U( ) ETU – MG16 1.50 package or Higher
IPK II CPUII Version 1.50 or Higher
SIP License
PVA(X)-U( ) ETU with PVA Combo Application package 1.00 or Higher and Elite IPK II CPUII
Version 2000 or Higher
Related Features
Reference the Elite IPK II VoIP (Voice over Internet Protocol) Installation Manual
Programming
VoIP Settings
When the PVA(X)-U( ) ETU is first purchased it has a factory default package installed. You must load the MG16
Application for the Elite IPK II KSU to recognize the VoIP MG16 ETU. [Reference the
PVA(X)-U( ) ETU Firmware
upgrade installation procedure
].