NEC Electra Elite IPK II System - Page 61

Electra Elite IPK II Document Revision 4C
Alarm Reports 2 - 37
Required Component(s)
CTA/CTU and available USB port
- OR -
Available RS-232 Serial Communications Port
Related Features
None
Programming
 15-02-19 Multiline Telephone Basic Data Setup – CTA Data Communications Setup
This Program must be set to Non-Procedural Mode (1) when using CTA/CTU adapters for
printouts.
0 = CTI Mode
1 = Non-Procedural Mode (Non-SCS)
 15-02-20 Multiline Telephone Basic Data Setup – Baud Rate for CTA Port
0 = 4800bps
1 = 9600bps
2 = 19200bps (default)
 90-10-01 System Alarm Setup – Alarm Type
0 = Not Set (default)
1 = Major Alarm
2 = Minor Alarm
 90-10-02 System Alarm Setup – Report
0 = No Report (no autodial) (default)
1 = Report (autodial)
 90-11-01 System Alarm Report – System Alarm Display Telephone
Assign the display multiline extension number that should receive system alarms.
Extension Number (up to eight digits).
No default is assigned
 90-12-05 System Alarm Output – Clear All Alarm Reports
Clear all alarms.
All Clear?
0 = No
1 = Yes