NEC Electra Elite IPK II System - Page 610

Document Revision 4C Electra Elite IPK II
2 - 586 IP Trunk (SIP) – MG16
 21-17-01 IP Trunk (SIP) Calling Party Number Setup for Trunk
Assign the Caller Party Number for each IP trunk. The assigned number is sent to the central
office when the caller places an outgoing call. If the Calling Party Number is assigned by both
PRG 21-17 and PRG 21-18/PRG 21-19, then the system uses the entry in PRG 21-18/PRG
21-19.
Entries: 1~0,
, # (to equal up to 16 digits)
(Default: None)
 21-19-01 IP Trunk (SIP) Calling Party Number Setup for Extension
Assign the Calling Party Number for each extension. The assigned number is sent to the central
office when the caller places an outgoing call. If the Calling Party Number is assigned by both
Program 21-17 and Program 21-18/Program 21-19, the system uses the data in Program 21-18/
Program 21-19.
Entries: 1~0,
, # (to equal up to 16 digits)
(Default: None)
SIP CODEC Trunk
 84-13-01 SIP Trunk CODEC Information Basic Setup – G.711 Audio Frame Number
Set the G.711 Audio Frame Number.
Entries: 2~3
(Default: 2)
 84-13-02 SIP Trunk CODEC Information Basic Setup – G.711 Voice Activity Detection Mode
Enable (1)/Disable (0) the G.711 VAD Detection Mode.
(Default: 0)
 84-13-03 SIP Trunk CODEC Information Basic Setup – G.711 Type
Define the G.711 type.
Entries: 0 = A-law, 1 = -law
(Default: 1)
 84-13-04 SIP Trunk CODEC Information Basic Setup – G.711 Jitter Buffer (min)
Set the minimum (0~200 ms) G.711 Jitter Buffer.
(Default: 20)
 84-13-05 SIP Trunk CODEC Information Basic Setup – G.711 Jitter Buffer (Average)
Set the average (0~200 ms) G.711 Jitter Buffer type.
(Default: 40)
 84-13-06 SIP Trunk CODEC Information Basic Setup – G.711 Jitter Buffer (max)
Set the maximum (0~200 ms) G.711 Jitter Buffer.
(Default: 60)