Document Revision 4C Electra Elite IPK II
2 - 600 IPK II In-Mail
Programming
10-09-01 DTMF and Dial Tone Circuit Setup
Assign at least one circuit for DTMF reception (type 0 or 1).
Use the following as a guide when allocating DTMF receivers:
In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
11-07-01 Department Group Pilot Numbers – Dial
Assign a Department Group pilot number for the Voice Mail (eight digits maximum). The
extensions are assigned to the group in Program 16-02-01.
11-12-52 Service Code Setup (for Service Access) – Live Monitoring (In-Mail)
Define access code used for In-Mail Live Monitoring (VRS). At default this program is not set.
15-02-26 Multiline Telephone Basic Data Setup – MSG Key Operation Mode
Determine whether an extension MSG key should function as a Message key (0) or Voice Mail
key (1) (Default = 0). If set as a Message key, the user can press the key to call the voice mail
only when they have new messages. If set as a Voice Mail key, it functions as a normal Voice
Mail key (it
is not active if Centralized Voice Mail is used).
15-02-28 Multiline Telephone Basic Data setup – Message Waiting Lamp Color
Select whether the Message Wait LED located at the top of the multiline terminal flashes green
(0) or red (1) when a Message Wait indication is flashing. By default, this option is set to 1.
15-03-01 Single Line Telephone Basic Data Setup – SLT Signaling Type
For each Electra Elite IPK II voice mail extension, this option must be set to 0.
15-03-03 Single Line Telephone Basic Data Setup – Terminal Type
Set all SLIU ports used for Voice Mail as type 1.
15-03-09 Single Line Telephone Basic Data Setup – Caller ID Function – for External Module
Set to 0 when voice mail is used or the integration code for the disconnect function
is incorrect.
To Next Page
Loading...
