Electra Elite IPK II Document Revision 4C
IPK II In-Mail 2 - 603
22-04-01 Incoming Extension Ring Group Assignment
Assign Ring Group 102 for an In-Skin/External Voice Mail, or 103 for a Central Voice Mail as the
destination.
For Either Method:
22-04-01 Incoming Extension Ring Group Assignment
To enable Voice Mail Overflow, assign selected extensions to a Ring Group that rings for
unanswered DILs to Voice Mail ports. In Program 22-06, enter 1 to enable overflow ringing.
22-08-01 DIL/IRG No Answer Destination
For Voice Mail Overflow, enter the Ring Group that unanswered DILs to Voice Mail ring after the
DIL Call Waiting time (Program 22-01-04).
24-02-03 System Options for Transfer – Delayed Call Forwarding Time
Set the time a transferred call waits at a forwarded extension before routing to the called
extension mailbox.
45-01-01 Voice Mail Integration Options – Voice Mail Department Group Number
Assign which Extension (Department) Group number is to be assigned as the voice mail group.
An entry of 0 means no voice mail is installed.
Department Groups: 0 (default), 1~64
45-01-02 Voice Mail Integration Options – Voice Mail Master Name
Enter the Voice Mail master name up to 12 characters.
45-01-04 Voice Mail Integration Options – Park and Page
Enable (1)/Disable (0) the system ability to process the Voice Mail Park and Page (
)
commands. You should normally enable this option Default is 1.
45-01-05 Voice Mail Integration Options – Message Wait
Enable (1)/Disable (0) the system ability to process the Voice Mail Message Wait (#) commands.
You should normally enable this option. If enabled, be sure that the programmed Message
Notification strings do not contain #9 for trunk access. When using an external voice mail and
centrex transfer, this option should be disabled or the service code #3 in Program 11-12-42 must
be changed.
45-01-06 Voice Mail Integration Options – Record Alert Tone Interval Time
This time (0~64800 seconds) sets the interval between Voice Mail Conversation Record alerts.
Default is 30
45-01-14 Voice Mail Integration Options – CCIS Centralized Voice Mail Number
Assign (for remote stations only) the pilot number (up to eight digits) to Centralized Voice Mail
over CCIS Link. Default is No Setting.
45-01-15 Voice Mail Integration Options – Analog Voice Mail Protocol Selection
Select whether Fixed codes (0) or the codes used in Program 45-04 (1) are used for analog
voice mail protocol. Default is 0. Version 1500 or higher is required.
45-01-16 Voice Mail Integration Options – Voice Mail Fax Digit Add Assignment
Assign up to four digits in front of the station number sent to the SLT port when a call is
forwarded. Default is None. Version 1500 or higher is required.
To Next Page
Loading...
