NEC Electra Elite IPK II System - Page 629

Electra Elite IPK II Document Revision 4C
IPK II In-Mail 2 - 605
 47-12-01
through
47-12-08 IPKI II In-Mail Answer Schedules
 47-13-01 IPKI II In-Mail Dial Action Tables
Refer to the Electra Elite IPK II In-Mail System Guide, for complete programming details.
 80-03-01 DTMF Tone Receiver Setup – Detect Level
80-04-01 Call Progress Tone Detector Setup – Detect Level
Set the criteria for DTMF dial, ringback and busy tones. Default for Type 1~5 for 80-03-01 is 0.
Default for Type 1~3 for 80-04-01 is 0 (-25 dBm); for Type 4 and 5 default is 0.
ACD Delay Announcement:
Use only if Master Mailboxes are used for ACD Delay Announcements.
 41-19-01 ACD Voice Mail Delay Announcement – Delay Message Start Timer
Determine the time the system waits before playing the Delay Message. Version 2000 or
higher is required.
Options
0 ~ 64800 seconds
(default: 0)
 41-19-02 ACD Voice Mail Delay Announcement – Mailbox Number for 1st Announcement Message
Assign Voice Mail ACD Announcement Mailbox as the message source for the 1st
Announcement Message. Version 2000 or higher is required.
Options
Dial up to eight digits
(default: No Setting)
 41-19-03 ACD Voice Mail Delay Announcement – 1st Delay Message Sending Count
Determine the 1st Delay Message Sending Count. This entry must be set to 1 or higher for the
message to play. Version 2000 or higher is required.
Options
0 = No message played, 1 ~ 255
(default: 0)
 41-19-04 ACD Voice Mail Delay Announcement – Mailbox Number for 2nd Announcement Message
Assign Voice Mail ACD Announcement Mailboxes as the message source for the 2nd
Announcement Message.
Options
Dial up to eight digits
(default: No Setting)
 41-19-05 ACD Voice Mail Delay Announcement – 2nd Delay Message Sending Count
Determine the 2nd Delay Message Sending Count. This entry must be set to 1 or higher for the
message to play.
Options
0 = No message played, 1 ~ 255
(default: 0)