NEC Electra Elite IPK II System - Page 650

Document Revision 4C Electra Elite IPK II
2 - 626 IPK II VoIP Management System
MEGACO Station Card Scenarios
Optional Device Configurations
Features Summary (Main Site)
Network Equipment
IVM
Main
Discover
Phones
Monitor
Phones
Monitor
Station
Card
Perform
Active
Tests
Notification
IPK HUB ETU/HUB YS NO NO NO YS NO
SNMP switch (Bridge MIB and Mirroring) YS YS YS YS YS YS
SNMP switch (Bridge MIB – No
Mirroring)
YS YS NO NO YS NO
Non-SNMP enabled switch (Mirroring) YS NO NO NO YS NO
Non-SNMP enabled switch (No
Mirroring)
YS NO NO NO YS NO
MEGACO Station Card Scenarios
Optional Device Configurations
Features Summary (Remote Site)
Network Equipment
IVM
Main
Discover
Phones
Monitor
Phones
Monitor
Station
Card
Perform
Active
Tests
Notification
HUB YS NO NO N/A YS NO
HUB NO NO NO N/A NO NO
SNMP switch (Bridge MIB and Mirroring) YS YS YS N/A YS YS
SNMP switch (Bridge MIB and Mirroring) NO NO NO N/A NO NO
SNMP switch (Bridge MIB – No
Mirroring)
YS YS NO N/A YS NO
SNMP switch (Bridge MIB – No
Mirroring)
NO NO NO N/A NO NO
Non-SNMP enabled switch (Mirroring) YS NO NO N/A YS NO
Non-SNMP enabled switch (Mirroring) NO NO NO N/A NO NO
Non-SNMP enabled switch (No
Mirroring)
YS NO NO N/A YS NO
Non-SNMP enabled switch (No
Mirroring)
NO NO NO N/A NO NO
 The IVM should always be optimally positioned where it can monitor a majority of the telephone traffic.
 Active tests can be performed only between switches that are configured to be managed by an IVM appliance. When the Discovery
process is unsuccessful, only schedule-triggered Active Tests can be performed between these switches.
 When there is an IVM at the MEGACO site, but not at the remote site, calls from the remote are recorded under the MEGACO
Station Card, but no summary reporting for the individual telephones at the remote site is provided. The IP address of the remote
telephones is displayed on the MEGACO Station call records.