Electra Elite IPK II Document Revision 4C
IPK II VoIP Management System 2 - 631
Remote IP Trunk Card site
Optional Device Configurations
Features Summary (Remote)
Network Equipment IVM
Monitor
Trunk
Perform
Active
Tests
Notification
IPK HUB ETU/HUB YS YS YS YS
SNMP switch (Bridge MIB and Mirroring) YS YS YS YS
SNMP switch (Bridge MIB – No Mirroring) YS NO YS NO
Non-SNMP enabled switch (Mirroring) YS YS YS YS
Non-SNMP enabled switch (No Mirroring) YS NO YS NO
Router and dumb HUB YS YS YS YS
The IVM should always be optimally positioned where it can monitor a majority of the telephone traffic.
Active tests can be performed only between switches that are configured to be managed by an IVM appliance.
When the Discovery process is unsuccessful, only schedule-triggered Active Tests can be performed between
these switches.
Telephones connected to a HUB cannot be discovered and therefore cannot be monitored.
To Next Page
Loading...
