NEC Electra Elite IPK II System - Page 676

Document Revision 4C Electra Elite IPK II
2 - 652 ISDN Compatibility
Programming Flowchart of ISDN-PRI – Placing Calls
Start
In 10-03-01, determine the mode of the DTI( )-U40 ETU
(0=not set, 1=T-Bus)
In 10-03-03, enter
'0'.
In 10-03-03, enter
'1'.
In 10-03-04, select the Layer 3 timer type (1-5). The timer value is
set up in Program 81-06 (T-Bus)
In 10-03-06, determine the length of cable used to connect from the CSU to
the DTI( )-U40 ETU
(0=0-40m, 1=40-81m, 2=81-122m, 3=122-162m, 4=162-200m).
YesNo
In 10-03-08, enter
'0'.
In 10-03-08, enter
'1'.
OverlapEnblock
In 10-03-09, select either
Keypad Facility (0) or
Called Party Number (1) for
the dial information element.
Go To
A
Is the Dial
Sending Mode
Enblock or
Overlap
Sending?
Is the CRC
Multi-Frame
(CRC4)
used?
Should system users be able to place
outgoing calls on trunks?
20-08-02, enter ‘1’ to
enable outgoing
calls.
In 20-08-02, enter 0 to
disable outgoing calls.
YesNo
In 20-06-01, assign
Class of Service to extensions.
Stop
Should telco display the
calling number for outgoing
calls?
In 20-08-13, enter 0 to
disable calling number
display by telco.
In 20-08-13, enter 1 to
enable calling number
display by telco.
In 20-13-31, enter
0 to disable trunk
ID display by telco.
In 20-13-31, enter
1 to enable trunk
ID display by telco.
Should telco display the
trunk identification for
outgoing calls the extension
places?
YesNo
YesNo