NEC Electra Elite IPK II System - Page 778

Document Revision 4C Electra Elite IPK II
2 - 754 Off-Hook Signaling
 15-02-12 Multiline Telephone Basic Data Setup – Off-Hook Ringing
For each extension, set Off-Hook Ringing type: 0 (muted), 1 (none), 3 (beep in speaker), 4 (beep
in handset), 5 (Speaker & Handset Beep). DID, DNIS and DIL trunks can use any of the four
options - normal/ring group trunks can use only options 0 or 1.
 15-07-01 Programmable Function Keys
Assign a function key for Off-Hook Signaling (code 33).
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
 20-09-07 Class of Service Options (Incoming Call Service) – Call Queuing
Enable (1)/Disable (0) station call queuing.
(default: 1)
 Must be set to 1 to enable automatic Off-Hook Signaling.
 20-13-05 Class of Service Options (Supplementary Service) – Intercom Off-Hook Signaling
Enable (1)/Disable (0) the extension ability to receive Off-Hook Signaling.
(default: 1)
 20-13-06 Class of Service Options (Supplementary Service) – Automatic Off-Hook Signaling
(Automatic Override)
Enable (1)/Disable (0) the extension ability to automatically send Off-Hook Signals while busy on
a handset call.
(default: 1)
 20-13-34 Class of Service Options (Supplementary Service) – Block Manual Off-Hook Signaling
Turn off (0) or on (1) an extension ability to block off-hook signals manually sent from a
co-worker.
(default: 0)
 20-18-06 Service Tone Timers – Interval of Call Waiting Tone
Set the time (0~64800 seconds) between Off-Hook Signaling alerts.
(default: 10)
 80-01-02 Service Tone Setup – Basic Tone Number
(Default: 0).
Refer to Table 2-27 Service Tone Setup, Program 80-01-02 on page 2-480.
 80-01-39 Service Tone Setup – Ring Busy Tone (Service Tone 39)
Define Ring Busy Tone.
Refer to Service Tone 39 Ring Busy Tone on page 2-478
 Changing this program requires a KSU reset to take effect.