Document Revision 4C Electra Elite IPK II
2 - 54 Ancillary Device Connection
A single line telephone connected to an APR-U/AP(R)-R Unit or APA-U/AP(A)-R Unit
cannot perform Trunk-to-Trunk Transfer and does not support a conference with itself and
two outside parties.
A single line telephone connected to an APR-U/AP(R)-R Unit or APA-U/AP(A)-R Unit does
not support Message Waiting Indication or Caller ID Indication.
An AP(R)-R Unit (analog port adapter with ringer) can be installed on a multiline terminal
and function separately from the multiline terminal.
When PRG 10-03-06 is assigned as APR you cannot manually assign a port number for an
APR. The system uses ports 193~256 (starting with 256 and working down) for a total of
64 APR ports. APR 1 uses port 256, and APR 2 uses port 255, and so on (Version 1100
or lower.)
The multiline terminal must be connected to an ESIB(8)-U20 ETU, and the ESIB(8)-U20
ETU must have an ESIE(8)-U20 ETU installed [ESIB/E(16)]. The corresponding port on the
ESIE(8)-U20 ETU does not support a station or other hardware when used by the APR for
channel 2.
When PRG 10-03-06 is assigned as APR you cannot manually assign a port number for the
APR. The system uses the corresponding port on the ESIE(8)-U20 ETU as the port
number. For example, if a multiline terminal is connected to port 1 of the ESIB/E(16)-U20,
the APR would use port 9 of the ESIB/E(16)-U20. (Version 1500 or higher required.)
The D
term
IP Gig Adaptor has three RJ45 connections on the back enabling a Gigabit
connection from the LAN, a Gigabit connection to the PC, and a 10/100 connection to the
phone.
When using a gigabit connection, a straight cable category 5e or higher is required
(maximum length 100 meters).
DTP-2DT-1 and DTR-2DT-1 telephones have a built in APA adapter.
Phones that have an APR/APA installed do not pass voice to a trunk until the interdigit timer
expires (Program 21-01-03).
Default Settings
None
Related Features
Electra Elite IPK Terminals
Electra Elite Terminal Migration
To Next Page
Loading...
