Document Revision 4C Electra Elite IPK II
2 - 766 Operator
Required Component(s)
None
Related Features
Attendant Call Queuing
Programming
20-01-01 System Options – Operator Access Mode
Set up priority of a call when calling an operator telephone (0 = Step, 1 = Circular).
(default: 0)
20-17-01 Operator Extension – Operator’s Extension Number
Designate an extension an operator. When an extension user dials 0 or 9 (defined by Program
11-01, Type 5), calls go to the operator selected in this program.
(default: 101)
If you do not assign an extension in Program 90-11-01, system alarms appear on the extension
assigned in this option.
20-35-01 extension Operator Setting
Assign an extension to an operator group.
(Input: 0~15)
(default: 0)
20-36-01 Trunk’s Operator Mode
Assign a trunk to an operator group.
(Input: 0~15)
(default: 0)
20-37-01 Operator Extension Group Setup
Define the initial operator extension in the operator group.
(default: None)
20-38-01 Operator Group Setting
Set up priority of a call when calling an operator telephone.
(0 = Step, 1 = Circular)
(default: 0)
Operation
Refer to the individual features for operation.
To Next Page
Loading...
