NEC Electra Elite IPK II System - Page 860

Document Revision 4C Electra Elite IPK II
2 - 836 Repeat Redial
Related Features
Automatic Route Selection
Central Office Calls, Placing
Last Number Redial
Save Number Dialed
Single Line Telephones, Analog 500/2500 Sets
Programming
 15-07-01 Programmable Function Keys
Assign a function key for Repeat Redial (code 29).
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
 20-08-07 Class of Service Options (Outgoing Call Service) – Repeat Redial
Enable (1)/Disable (0) an extension ability to use Repeat Redial.
 21-08-01 Repeat Dial Setup – Repeat Redial Count
Set how many times (0~255) Repeat Redial automatically repeats if the call does not go
through.
(default: 3)
 21-08-02 Repeat Dial Setup – Repeat Redial Interval Time
Set the time between Repeat Redial attempts (0~64800 seconds).
(default: 60)
 21-08-03 Repeat Dial Setup – Repeat Dial Calling Timer
Set the time (0~64800 seconds) the system waits for the called party to answer after a Repeat
Redial. If the called party does not answer during this time, the system hangs up and tries again
(after the Repeat Redial Interval Time). For unanswered calls, the total time between retries is
the sum of PRG 21-08-02 and PRG 21-08-03.
(default: 30)
 21-08-04 Repeat Dial Setup – Time for Send Busy Tone for ISDN Trunk
Set the time (0~64800 seconds) to send out Busy Tone with an ISDN line, when called party is
busy.
(default: 0)