NEC Electra Elite IPK II System - Page 902

Document Revision 4C Electra Elite IPK II
2 - 878 Selectable Ring Tones
Programming
 11-11-20 Service Code Setup (for Setup/Entry Operation) – Change Incoming CO and ICM Ring
Tones
If required, change the service code used for changing the incoming ring tones heard for CO and
ICM calls (Default: 720).
 11-11-21 Service Code Setup (for Setup/Entry Operation) – Check Incoming Ring Tones
If required, change the service code used for checking how the incoming ring tones sound.
(Default: 711).
 15-02-02 MultiLine Telephone Basic Data Setup – Trunk Ring Tone
Set the tone (pitch) of the incoming trunk ring for the extension port you are programming.
(default: 2)
 15-02-03 Multiline Telephone Basic Data Setup – Extension Ring Tone
Set the tone (pitch) of the incoming extension call ring for the extension port you are
programming. Also refer to program 15-08.
(default: 8)
 15-08-01 Incoming Virtual Extension Ring Tone Setup
Assign a ring tone pattern (0~4) to incoming virtual extensions assigned to a Virtual Extension
key (Program 15-07). If you enable ringing for the key in Program 15-09, the key rings with the
tone you set in this program. Also see Program 22-03.
(default: 0)
 15-10-01 Incoming Virtual Extension Ring Tone Order Setup
Set the priority (1~4) for the Virtual Extension Ring Tones set in Program 15-08. When Virtual
Extension calls ring an extension simultaneously, the tone with the highest order number (e.g.,
1) rings. The other keys just flash.
(default: 1~4 = 0~3)
1 = High 5 = Ring Tone 2
2 = Mid Range 6 = Ring Tone 3
3 = Low 7 = Ring Tone 4
4 = Ring Tone 1 8 = Ring Tone 5
1 = High 5 = Ring Tone 2
2 = Mid Range 6 = Ring Tone 3
3 = Low 7 = Ring Tone 4
4 = Ring Tone 1 8 = Ring Tone 5