EasyManuals Logo

NEC Electra Elite IPK II System User Manual

NEC Electra Elite IPK II System
1190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #910 background imageLoading...
Page #910 background image
Document Revision 4C Electra Elite IPK II
2 - 886 Single Line Telephones, Analog 500/2500 Sets
 15-03-01 Single Line Telephone Basic Data Setup – SLT Signaling Type
Enter 0 if single line telephone is a 500 type (dial pulse). Enter 1 if single line telephone is a 2500
type (DTMF).
(default: 1)
 15-03-03 Single Line Telephone Basic Data Setup – Terminal Type
Enter 0 for normal 500/2500 type telephones. Enter 1 if a Voice Mail port (refer to Voice Mail for
more information).
(default: 0)
 20-03-02 System Options for Single Line Telephones – Ignore Received DP Dial on DTMF SLT Port
Define whether the system should receive dial pulse and DTMF signals (0) or ignore dial pulse
and only accept DTMF signals (1).
(default: 0)
 20-03-03 System Options for Single Line Telephones – SLT DTMF Dial to Trunk Lines
Set the SLT phones to (0). Collect all digits before sending or (1), send out immediately after
receiving. When using a third-party external paging device, set this option to 1. In addition, set
Program 20-03-04 to 1.
(default: 0)
 20-03-04 System Options for Single Line Telephones – Dial Sending Start Time for SLT or ARS
Set the time (0~64800 seconds) before the first digit is sent out. When using a third-party
external paging device, set this option to 1. In addition, set Program 20-03-03 to 1.
(default: 3)
 20-06-01 Class of Service for Extensions
Assign a unique Class of Service for Dual OPX telephones only when using Continued Dialing.
 20-13-13 Class of Service Options (Supplementary Service) – Continued Dialing (DTMF) Signal on
ICM Call
Set option to 0 to prevent dual DTMF tones when using Continued Dialing.
 20-15-01 Ring Cycle Setup – Normal Incoming Call on Trunk
Define the ringing cycle (1~13) for normal incoming trunk calls (DIL, ring group, etc.).
(default: 8)
 20-15-03 Ring Cycle Setup – Incoming Internal Call
Define the ringing cycle (1~13) for ICM calls.
(default: 12)
 20-15-05 Ring Cycle Setup – DID/DDI
Define the ringing cycle (1~13) for DID calls.
(default: 8)
 80-03-01
through
80-03-08 DTMF Tone Receiver Setup
 80-04-01 Call Progress Tone Detector Setup – Detect Level
If required, modify the criteria for dial tone detection and call progress tone detection for the
DTMF tones received at a single line telephone.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Electra Elite IPK II System and is the answer not in the manual?

NEC Electra Elite IPK II System Specifications

General IconGeneral
BrandNEC
ModelElectra Elite IPK II System
CategoryTelephone System
LanguageEnglish

Related product manuals