NEC Electra Elite IPK II System - Page 931

Electra Elite IPK II Document Revision 4C
Speed Dial – System/Group/Station 2 - 907
6. Enter the name associated with the Speed Dialing number (display telephones only).
7. Press Hold.
8. Press Speaker to hang up.
To dial a Station Speed Dialing number:
1. Press Speaker.
2. Dial
#7 (default Service Code).
- OR -
Press the System Speed Dialing key (Service Code 751: 27).
 To preselect, press a line key in step 1 (instead of Speaker).
3. Dial the Station Speed Dial buffer number (0 ~9).
Key for Entering Names
Use this keypad
digit . . .
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
  Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “
# $ % & ’ ( ) ô Õ ú ä ö ü 
 Enter characters:
 + , - . / : ; < = > ? B E  S  ¢ £
## = Accepts an entry (only required if two letters on the same key are needed – ex: TOM).
Pressing
# again = Space.
Conf Clears the character entry one character at a time (used when entering the name).
Exit
Clears all the entries from the point of the flashing cursor and to the right (used when
entering the number, this clears both the number and name).