NEC Electra Elite IPK II System - Page 952

Document Revision 4C Electra Elite IPK II
2 - 928 Station Message Detail Recording
 35-02-03 SMDR Output Options – Trunk Number or Name
Select whether the system should display the trunk name (0) or the number (1) on SMDR
reports
(default: 1)
 If this option is set to 0, Program 35-02-14 must be set to 0.
 35-02-04 SMDR Output Options – Summary (Daily)
 35-02-05 SMDR Output Options – Summary (Weekly)
 35-02-06 SMDR Output Options – Summary (Monthly)
Enter 1 to enable a summary report. Enter 0 to disable a summary report. The daily report
prints every day at midnight. The weekly report prints every Sunday night at midnight. The
monthly report prints at midnight on the last day of the month.
(default: 1)
 35-02-07 SMDR Output Options – Toll Charge Cost
Set this option to (1) have the SMDR report include toll charges.
(default: 1)
 35-02-08 SMDR Output Options – Incoming Call
Enter 1 if you want the SMDR report to include incoming calls. Enter 0 if you want the SMDR
report to exclude incoming calls.
(default: 1)
 35-02-09 SMDR Output Options – Extension Number or Name
Enter 0 if you want the SMDR report to include the extension name. Enter 1 if you want the
SMDR report to include the extension number.
(default: 1)
 35-02-10 SMDR Output Options – All Lines Busy (ALB) Output
Enter 1 to report information when all lines in a group are busy and an extension user tries to
access the group. Enter 0 if this information should not be included.
(default: 0)
 35-02-11 SMDR Output Options – Walking Toll Restriction Table Number
(default: 1)
 35-02-12 SMDR Output Options – DID Table Name Output
Determine if the DID table name should be displayed for incoming DID calls.
0 = Not Displayed
1 = Displayed
(default: 0)
 35-02-13 SMDR Output Options – CLI Output When DID to Trunk
Determine if the Caller ID should be displayed when the incoming DID number is transferred to
an outgoing trunk.
0 = Not Displayed
1 = Displayed
(default: 0)