NEC Electra Elite IPK II System - Page 957

Electra Elite IPK II Document Revision 4C
Station Name Assignment – User Programmable 2 - 933
5. Press the Hold key.
6. Press Speaker to hang up.
Table 2-38 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ ¨ Á À Â Ã Ç É Ê ì ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü


Enter characters:
 + , - . / : ; < = > ? B E  S  ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed
– ex: TOM). Pressing # again = Space. (In system programming mode, use
the right arrow Softkey instead to accept and/or add a space.)
Conf
Clear the character entry one character at a time.
Hold
Clear all the entries from the point of the flashing cursor and to the right.