Document Revision 4C Electra Elite IPK II
2 - 946 T1 Trunking (with ANI/DNIS Compatibility)
14-05-01 Trunk Group – Trunk Group Number
For ANI/DNIS, place all your ANI/DNIS trunks in Trunk Groups as required.
(default: Trunk ports 1~200 to Group 1 and Priority 1~200)
20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
20-09-02 Class of Service Options (Incoming Call Service) – Caller ID Display
Turn off (0) or on (1) the Caller ID display at an extension.
(default: 0).
20-09-01 Class of Service Options (Incoming Call Service) – Second Call for DID/DISA/DIL/E&M
Override
Enable (1)/Disable (0) an extension ability to receive a second call from a DID, DISA, DIL, or Tie
Line caller. With this option set to 1, the destination extension must be busy for a second DNIS
caller to ring through. If the destination extension does not have a line or Call Appearance (CAP)
Key
available for the second call and a previous call is ringing the extension but has not yet
been answered, the second caller hears busy regardless of this program setting.
(default: 1)
20-14-01
through
20-14-12 Class of Service Options for DISA/E&M
Enable/disable Tie Line Class of Service options. Assign Tie Line Classes of Service in PRG
34-02. Up to 15 DISA/E&M Classes of Service can be defined.
(default: 0, 1, 1, 0, 1, 1, 1, 0, 0, 0, 0, 1)
22-02-01 Incoming Call Trunk Setup – Incoming Type
For each T1 trunk, set the Trunk Service Type to match the Telco’s connected T1 service. For
each T1 trunk that should support ANI/DNIS service, enter 7. (ANI/DNIS trunks must be
immediate start or wink start T1 trunks with E&M signaling.) For T1 loop/ground start trunks
defined as 0, Program 14-02-02 must be set to 1 for the trunks to ring and light correctly.
(default: 0)
22-13-01 DID Trunk Group to Translation Table Assignment
Assign DID translation tables to trunk groups.
DID Translation Tables: 1~20
Trunk Groups: 1~100
(default: 1)
34-01-01 E&M Tie Line Basic Setup – DID/E&M Start Signaling
For each ANI/DNIS trunk, set the start signaling mode to 1 (wink start).
34-01-03 E&M Tie Line Basic Setup – E&M Dial-In Mode
Determine if the incoming Tie Line call should be directed as an intercom call (0) or if it should
follow the DID Translation Table in Program 22-11 (1).
(default: 0)
34-01-04 E&M Tie Line Basic Setup – E&M Line Dial Tone
Determine whether the Tie Line should send dial tone to the calling system once the call is set
up (1) or not (0).
(default: 1)
To Next Page
Loading...
