Electra Elite IPK II Document Revision 4C
Tandem Ringing 2 - 951
Programming
15-07-01 Programmable Function Keys
Assign a function key for Tandem Ringing (code 80).
30-03-01 DSS Console Key Assignment
Assign a DSS function key for Tandem Ringing (code 80).
11-11-41 Service Code Setup (for Setup/Entry Operation) – Tandem Ringing
Define a service code to be used to set up Tandem Ringing
(Default: No Setting).
Operation
To set up Tandem Ringing:
1. Press Speaker at the extension considered to be the master telephone (optional).
2. Press the Tandem Ringing key (PRG 15-07 or SC 751: 80).
3. Dial 1 to set the feature.
4. Enter the extension number to be considered the slave telephone (the telephone that rings when
the master extension rings).
A confirmation tone is heard (if Speaker was used).
5. Press Speaker to hang up (if the key is lit).
While the feature is active, if either the master or slave telephone is on a call, no calls can be
placed or answered at the other extension until the busy telephone has hung up. Multiline
Terminals indicate “TANDEM IN USE” in the display and single line telephones hear a busy signal
when the handset is lifted.
To cancel Tandem Ringing:
1. Press the Tandem Ringing key (PRG 15-07 or SC 751: 80).
2. Dial 0 to cancel the feature.
To Next Page
Loading...
