NEC Electra Elite IPK II System User Manual

Electra Elite IPK II Document Revision 4C
TAPI Compatibility 2 - 969
Required Component(s)
 CPUII( )-U10 ETU should have LAN connection capability
 Compatible system software version
 PC Driver for the CTA: PC running Windows 2000 Professional or higher
 PC Driver for the CTU: PC running Windows 2000 Professional or higher
 A TAPI compatible Windows application
 ESIB(8)-U20/ESIE(8)-U20 ETU
Related Features
Data Communications
Headset Operation
Programming
 15-02-19 Multiline Telephone Basic Data Setup – CTA Data Communications Mode
Set the extension to use TAPI to 0 for PC connection.
Operation
TAPI operation is automatic once programmed in the telephone system and enabled in the PC TAPI
application, unless a headset is used.
Using the Headset with Automatic Answer:
1. With the multiline terminal in an idle state, press the Check key.
2. Press the Headset key (PRG 15-07 or SC 751: 05) twice.
3. Press the Clear key to return the display to idle.
 The Headset key blinks when Automatic Headset is activated.
 To cancel Automatic Headset, repeat these steps.
To redirect calls to the headset and disable the hookswitch (required for some TAPI features):
1. With the multiline terminal idle, press the Check key.

NEC Electra Elite IPK II System Specifications

General

Brand	NEC
Model	Electra Elite IPK II System
Category	Telephone System
Language	English